Offline Setup Error show Part not exist in BOM

When user see the error message "This part does not exist in the BOM of the assembly", user need to check on the MBOM version that used by current work order is it correct or not. (Refer to Figure 1.1)

                                                                               Figure 1.1

User need to go Production > Production Planning > Work Order Management to check whether current work order is using the correct version of the MBOM. 

If there's any changes made under this work order (Product ,MBOM, Route and etc.), pop up dialog and message will be show when enter to this screen. Error Message: (New version of BOM found, please confirm whether to apply to the work order) (Refer to Figure 1.2)

                                                                              Figure 1.2

Please make sure update the Work Order if there's any changes made. 

Action Required: User